Laser Starlink Pivot Mount FAQ - Cable Routing

Question: How do I route the cable through the Laser Starlink Pivot Mount?

Answer:
Model reference: PC-SLG3PI-813
Applies to: PC-SLG3PI-813

To route the cable on the Laser ChargeCore Starlink Gen 3 V4 Adjustable Pivot Mount:

1. Feed the Starlink cable through the hole on the side of the mast.
2. Guide the cable up through the slot in the adapter.
3. Plug the cable into your Starlink.
4. Make sure the plug is fully pushed in so it sits flat against the surface.
5. Slide the mast into position until it clicks.

Before final alignment, check that the cable is seated properly and is not pulling against the mount.