Smart Internal Door Lock FAQ - Factory Reset

Description:

Reset through the Connect SmartHome app or the thumb-latch sequence, then pair and register fingerprints again.

Question:

How do I factory reset the fingerprint door lock?

Answer:

Model reference: LSH-INDCB-905

Applies to: LSH-INDCB-905

If your SKU differs, search our support page by your Model SKU to find the correct article.

The Laser Smart Internal Door Lock with Fingerprint has two documented factory reset methods.

METHOD 1 - APP

Remove the lock from the Connect SmartHome app.

METHOD 2 - MANUAL RESET

1. On the interior knob, move the thumb latch from horizontal to vertical and then back to horizontal.

2. Repeat that full movement five times within five seconds.

3. The indicator turns blue when the lock enters reset mode.

4. Within ten seconds, touch the fingerprint sensor to clear the stored data.

5. A long beep confirms the reset. The lock is ready to connect to the app again.

After resetting, use the Connect SmartHome app to reconnect the lock and register authorised fingerprints again.

IMPORTANT: After reset, complete pairing and fingerprint registration immediately. The manual explains that the lock initially accepts any fingerprint before the authorised fingerprints are configured. Do not leave the lock in its initial setup state.

If you are uncertain whether the lock has reset, follow the exact illustrated manual instructions rather than trying an undocumented reset procedure.