Pool Fountain Speaker FAQ - Fountain Modes and Troubleshooting

Question: Why is the fountain not spraying, and how do I change its mode?

Answer:

Model reference: SP-FMPOOL-251

Applies to: SP-FMPOOL-251

If your SKU differs, search our support page by your Model SKU to find the correct article.

The fountain on the Laser Bluetooth Pool Speaker with Fountain only sprays while its base is sitting in water.

Short press the Fountain Button to cycle through:

- Maximum Height: steady spray up to about 50cm.

- Gradient: rising and falling spray from 10cm to 50cm.

- Music Sync: spray responds to the music, from 10cm to 40cm.

- Fountain off.

If it does not spray:

1. Check the speaker is on, a fountain mode is selected and the battery has enough charge.

2. Take it out of the water if it is not upright, is near strong pool jets or return inlets, or a blockage is suspected.

3. Turn it off and rinse the filter and nozzle with clean water. Do not use household cleaners or force open the sealed pump.

4. Check for damage, then return it upright to suitable water away from strong currents and test again.

Blockage protection resets automatically once the blockage is cleared. If the battery is low, dry the speaker and charging port completely before charging. If the fountain still will not spray, stop using it and contact Laser support.

Run the fountain for no more than six hours at a time. The pump only operates while the base is submerged. If the fountain was left selected when the speaker powered down, it starts again next time the speaker is turned on when its base is in water.